United Arab Emirates
Our Products
Our product range comtains a wide range of and ANTISCALANT
domestic trade name: pt3000a export trade name: pt3000a chemical type: water soluble polymer product use: reverse osmosis membrane pretreatment/antiscalant information on hazardous ingredients non-hazardous ingredients cas #: 52255-49-9 hazards identification health hazards: primary route of exposure: skin contact, eye contact, and inhalation inhalation: exposure to spray may cause irritation to the mucous membranes and respiratory system. skin contact: exposure to skin can cause irritation. Eye contact: material can cause irritation to eyes. Ingestion: material is not harmful if accidentally ingested. medical conditions aggravated by exposure: none known tlv (threshold limit value): n/a, no danger exists. first aid measures first aid for ingestion: if swallowed give 2 glasses of water to drink. Seek medical attention immediately. Never give anything by mouth to an unconscious person. first aid inhalation: remove to fresh air. In case of shortness of breath call a physician immediately. first aid eye contact: immediately flush eyes with plenty of water for at least 15 minutes. Seek medical attention immediately. first aid skin contact: wash exposed area with soap and water immediately. Remove and wash contaminated clothing. fire fighting measures auto ignition temperature: n/a flammable limits: lel (lower explosive limits) – not applicable flammable limits: uel (upper explosive limits) – not applicable flash point: not applicable fire fighting media: use media appropriate to primary cause of fire. Special fire fighting procedures: none known fire/explosion hazards: none known special procedures: use water spray to cool containers exposed to fire. Minimize exposure. Do not breathe fumes. Contain run-off. accidental release measures spill/leak clean-up procedures: if possible neutralize with alkaline soap. land spill: wearing recommended protective clothing and equipment, dike spill with soil, sand, or compatible commercial absorbent. Remove remaining liquid with a pump, vacuum truck, or absorb liquid in sand or commercial absorbent. Place waste in approved containers for disposal. Dispose waste according to local regulations. water spill: wear protective clothing and equipment. Stop flow. Dike contaminated water and remove for disposal and/or treatment. Notify proper authorities and all downstream users if possible. Dispose of with solid waste according to federal, state, and local regulations. ** caution : floor will be slippery. personal protection: wear a niosh approved (or equivalent) respirator (with an organic/acid gas cartridge and a dust filter) during spill clean-up and deactivation of the material. Protective clothing including chemical splash goggles, latex, nitrile, or buytl rubber full-length gloves, rubber apron made of nitrile or buytl rubber, and rubber overshoes must be worn during spill clean-ups and deactivation of material. If this material comes into contact with the skin during clean-up operations, immediately remove all contaminated clothing and wash exposed skin areas with soap and water. See section 4, first aid measures, for further information. handling and storage precautionary measures: avoid breathing spray. See section 8, exposure control/personal protection, prior to handling. storage conditions: the maximum storage temperature for this material is 55°c/131°f. The minimum storage temperature for this material is 0°c/32°f. Store in a well-ventilated area. Do not store this material in containers made of steel. exposure control/personal protection ventilation: use local exhaust ventilation at the point of dust or mist evolution respiratory protection: dust masks where spraying cannot be avoided. eye protection: safety glasses, splash goggles, and/or face shields (ansi z87.1 or approved equivalent). skin protection: use latex, neoprene, or rubber gloves, boots, and apron. Remove gloves after use; wash hands with soap and water. personal hygiene: observe ordinary measures of personal hygiene. stability and reactivity stability: this material is considered stable under specific conditions of storage, shipment, and/or use. See section 7, handling and storage, for specific conditions. hazardous polymerization: will not occur condition to avoid: none known incompatible materials: strong oxidizing or reducing agents hazardous decomposition products: none known toxicological information acute toxicity: mutagenicity: ames salmonella mutagenicity testing exhibits no evidence of mutagen presence. oral toxicity: rat ld50>100, 000 mg/kg dermal toxicity: not absorbed topically inhalation toxicity: none known skin irritation: rabbit; no irritation observed sensitizer: no human repeat insult patch test, not a sensitizer ecological information environmental toxicity: acute fish 96 hr lc50, flathead minnow: 750 mg/l, noec/loec 500/1000 acute daphnia 48 hr ec50: 743 mg/l, noec/loec 500/1000 acute purple sea urchin 40min. Ic25 mg/l: >10, noec/loec 10/>10 disposal incinerate liquid and contaminated solids in accordance with local regulations and permits. transport information: domestic date dot shipping name: not regulated dot hazard class: not regulated hazardous ingredients: none export data export shipping name: not regulated export hazard class: not regulated hazardous ingredients: none un number: none regulatory information sara section 313 notification (40cfr 372) this product does not contain toxic chemicals subject to the reporting requirements of section 313 of title iii of the superfund amendments and reauthorization act of 1986 and 40 cfr part 372. all components of this product are in compliance with the inventory listing requirements of the u.s toxic substance control act (tsca) chemical substance inventory. other information hmis hazard codes – health/flammability/reactivity; 0, 0, 0 nfpa hazard codes - health/flammability/reactivity; 0, 0, 0 made in u.s.a.
