LUV International Trdg. LLC.

Dubai, United Arab Emirates

SBT couplers is a parallel threaded system for reinforcing bars dia 16 mm. to 40 mm diameter.They produce full strength joint in the rebar connection. The ends of the reinforcing bar to be jointed are cut square and then enlarged by cold forging process to increase their core diameters to ensure that the joint is stronger than rebar. The couplers are usually supplied attached to the reinforcing bars.The end of the reinforcing bars to be jointed is sawn cut The sawn cut ends of the reinforcing bar is then enlarged by cold forging process to increase its core diameter. Standard metric thread is then cut onto the enlarged end. Finally splice the rebar by using SBT parallel threaded couplers

• MAINS VOLTAGES (V)3 PHASE
• WEIGHT KGS1,263
• MACHINE CODESBTxxxxxx
• MACHINE DIAMETER12mm. to 60mm.

Upsetting splice is a parallel threaded rebar mechanical splice designed for the connection of concrete reinforcement bars, for diameters 12 to 40 mm. The full performance of upsetting rebar splices is stronger than the reinforcement bar and guarantees bar break under tensile stress. This machine is the preparative machine of rebar connecting in construction. Its main function is upsetting and thickening the end part of rebar to raise the rebar area.

• Thread Size(mm)21
• Product CodeSBTTC0016
• Length(mm)118
• Bar Dia.(mm)16
• Outer Dia.(mm)31

Remove the unnecessary attachments on the end of the reinforcing bars before extrusion such as rust, dirt, mortar and burr which affect the installation of the coupler. The ends of the reinforcing bars should be straight. Mark the reinforcing bar with half of the couplers length. Insert the reinforcing bar into the coupler up to the mark and press, using special Hydraulic Pressing Machine with suitable moulds. Then insert the second rebar into the other half of the coupler and Press. Pressure Gauge Calibration should be Certified Oil Pie should be Connected Tightly to avoid any injury Check the oil Level Make sure that required pressure is given to the machine for pressing Start pressing from the middle of the Coupler, but first pressing line from the middle should be pressed at last.For repair or retrofit works. Fits any cold shear cut bar end. No reduction of the cross section area of the Bar.