Other Products / Services #5823243

Constant Volume of conditioned air (CAV) is supplied to each VAV unit with variable static pressure. The VAV damper modulates in response to variable static pressure to deliver a constant air volume Vconst. to the conditioned zone by the set point value within the limits of Vmin to Vmax.

A cable tray system is a unit or assembly of units or sections and associated things forming a rigid structural system used to securely fasten or support cables and raceways. In other words.

• Cable trays support cable the way that roadway bridges support traffic.


• A bridge is a structure that provides safe Passage for traffic across open spans.


• Cable tray is the bridge that allows for safe transport of wires across open spans.


• Therefore, think of cable tray as the structural component of a buildings electrical system.

Cable trunking is available in different finish including epoxy coated, hot dip galvanized & in stainless steel. Robust, heavy duty oval conduit is the tidy, safe and professional way to complete and protect electrical wiring installations.

Control panel is a flat, typically vertical area where control or monitoring instruments are displayed.
We at Maxell Industries L.L.C do assemble Control Panels for various applications such as Cement batching using PLCs, Pump control using VFDs, AHU control through VFDs.

These are required with all the Main Distribution Boards which are connected to the external supply source.
These helps in improving the power factor at source

The square or rectangular shaped duct heaters can be manufactured in six basic designs as below:

1. Slip In Type
   
   
   
   • These heaters are designed in such a way that the frame dimensions are slightly smaller than duct dimensions. Slip-in heaters are designed so that the entire frame, except the terminal box, slips into the duct with inch clearance all around.
   
   
   
   


2. Flanged Heater-Removable Heater Section
   
   
   
   • These heaters consist of a slip-in type mounted in a flanged duct section. Frame dimensions are made to match exactly to the duct dimensions. The frame is then attached directly to external flanges of the duct where the slip in portion could be pulled out without removing the flanges from the duct.
   
   
   
   


3. Flanged Heater-Non Removable Heater Section
   
   
   
   • In this design the frame of the heater is made in such a way that it exactly fits the flanges of the duct i.e. the inside face dimensions exactly matches the duct dimensions. The heater frame is attached to matching turned out duct flanges
   
   
   
   


4. Stab In Heater
   
   
   
   • Maxell manufactures wide range of stab in heaters for sensible heating. Most commonly used with FCUs. The compact design of stab in heaters makes it more economical and a widely used product across the globe.
   
   
   
   


5. Fan Heater
   
   
   
   • The Maxell fan heater series features a compact design thats almost half the size of comparable utility heaters with similar heating capacities. Maxell fan heaters are designed to mount on ceilings, floor and wall.
   
   
   
   


6. Round Duct Heater
   
   
   
   • Heaters specifically designed for installation to commercially rated round ducts. Heaters are available for installation to spiral single ducts with inside diameters of 4 to 44 inches.
   
   
   
   

Synchronization panels are mainly designed and used to meet power system requirements.
These panels provide manual as well as automatic synchronizing function for one or more generator breakers.
They are widely used in synchronizing generators and offering multiplexing solutions.