FOCUS INT. METALIC.IND LLC

United Arab Emirates

A Type tested assemblies to BS EN 60439-1 . The design is according to client requirements. Routine tests are conducted on all Sub Mani Distribution Boards according to IEC 60439-1 Sub Clauses. 8.3.1, 8.3.2, 8.3.3, 8.3.4.RATED OPERATING VOLTAGE: Upto 660VRATED CURRENT : Upto 1250AASTA Certified Aseemblies up to 50kA for 1 secDEGREE OF PROTECTION: UPTO ip-66CONSTRUCTION IN FORM: 2, 3 OR 4

Rating Upto : 600KVAR BankRATED OPERATING VOLTAGE: Up to 660VDEGREE OF PROTECTION: UPTO IP-65CONSTRUCTION IN FORM: Form 2 & 4SHEET STEEL ENCLSOURE: 1.5MM or 2.0 mm

Manufacturing of MDB with type tested assemblies to IEC & BS EN 60439-1. The Design is incorporated according to clients and consultants requirements as per the ADDC, SEWA, FEWA and other local authorities of UAE approval.RATED OPERATING VOLTAGE Upto : 660VRATED CURRENT Upto : 3200A ASTA Certified 50KA for 1 sec.DEGREE OF PROTECTION : IP-54 & IP-55SHEET STEEL THICKNESS: 1.5mm or 2.0 mm

Swimming Pool Control PanelsFountain Control PanelsLighting Control PanelsMotor Control CentresFan Control PanelsControl Panels are complied with IEC & BS EN 60439-1, Front and rear access with FORM -2 and FORM-4 construction.

A motor control center (MCC) is an assembly of one or more enclosed sections having a common power bus and principally containing motor control units. A motor control center can include variable frequency drives, programmable controllers, and metering and may also be the electrical service entrance for the building. Motor control centres are usually used for low voltage three-phase alternating current motors from 230 volts to 600 volts.A motor controller include a manual or automatic means for starting and stopping the motor, selecting forward or reverse rotation, selecting and regulating the speed, regulating or limiting the torque, and protecting against overloads and faults. A Type tested Assemblies to IEC & BS EN 60439-1RATED OPERATING VOLTAGE : Upto 660VRATED CURRENT: Upto 3200ADEGREE OF PROTECTION: Up to IP-55CONSTRUCTION IN FORM: Form 2, 4 Type 7 Construction.SHEET STEEL THICKNESS: 1.5mm or 2.0 mm

Final Distribution boards rated Upto 250A fulfil complete range with custom design and according to client requirement. Available for Single Phase and Three Phase with protection standard of IP-31 Upto IP-55.RATED : Short Circuit Upto 15 KAWIRING: Using heat resistant wire ( 105 ) trirated BS 6231 with copper ends. Designed to provide high level of safety and reliability.

Isolator Panels is rated from 25A to onward manufacturing with International Standards as well as local authority rules and regulations.DEGREE OF PROTECTION: UPTO IP-66APPLICATIONS: Chillers, Air Conditioners