Intertech Trading Co. LLC Dubai

GripTight® High Pressure Test Plug - Test Open    End Pipes, Pipelines, Tubes and Pressure Vessels      Quickly and Safely  •    Unlike other plugs that can loosen and eject under  high pressure - even becoming dangerous     projectiles the GripTight actually uses test pressure    to seal more securely against the pipe's inner     diameter.  •    The greater the pressure - the greater the grip! The      result is safer installation, better sealing and all around safer testing. 

EST Group offers a complete line of tube plugs and plugging systems designed for quickly preparing and plugging leaking and degraded heat exchanger, condenser and boiler tubes. •  Quickly Prepare and Plug Leaking Heat Exchanger, Condenser and Boiler Tubes •  Install and Remove Plugs Without Welding or Explosives •  Locate and Identify Leaks  Tube Plugs are suitable for service in operating pressures up to 7, 000 psi (480 Bar) and are designed to be installed without welding or explosives. A variety of systems and tools are available for installation and removal. Tube Stabilizers are designed for stabilizing fractured or severed heat exchanger tubes while tube sleeving is designed to effectively repair damaged tube ends. Also available are Tube Testing Guns for locating and identifying leaking heat exchanger tubes.

Automated valves packages.- Pneumatic, Electric & Hydraulic actuators & Actuated Valves •   Design, engineering, selection, integration, supply and need-based assistance for automated valves    packages. •   In –house pool of engineers who have had product specific hands-on training on sizing, selection of    actuators and valves. Trained technicians who offer service support. •   Added expertise at engineering and design of control logic for shutdown/blow down & on-off valves •   Disaster recovery with data replication servers •   Integration and final FAT of automated  ESDV/SDV/BDV  packages.

GripTight Reverse Pressure (GTRP) test plugs     eliminate concerns over inadequate joint strength      when pressure testing welded flange connections  •   The plug and test flange act independently of each    other so that the weld joint is subjected to real world      stresses during pressure testing •   Flange to pipe welds are tested without needing to      pressurize the entire system •    Available for pipe sizes ranging from 2" to 12"      (DN50 - DN300). Larger sizes available upon request

EST’s Double Block & Bleed (DBB) Plug revolutionizes isolation    and testing of pipe connections. •  Positively Isolate Explosive Vapors From Hot Work Areas    When Performing Modifications and Repairs  •   Lightweight, aluminum and steel construction •  Uses less than a gallon of water, reducing waste/treatment    expense.  •   Plug is portable and easy to position.

G-Series Tube Testing Guns provide a safe, economical  way to test for leaks in heat exchanger tubes. Test    individual tubes for pinhole leaks using air pressure •  Uses readily available shop air pressure to conduct     reliable testing of tubes •   G-150 Tube Testing Guns are designed for use in Tube ID     ranges from 0.28” to 1.23” (7.1 mm to 31.2 mm). •   G-150A Tube Testing Guns are designed for use in Tube ID     ranges from 1.24” to 2.53” (31.5 mm to 64.3 mm).