Post Your Requirement Menu

Welcome User

Other Products / Services

Leading Manufacturer, Supplier & Retailer of Air and Odor Treatment, Valves and Flow Control, Water Hammer Protections Equipment and reverse.

Air and Odor Treatment

Bio Filter 2) Activated Carbon Filter 3) Chemical Scrubber 4) Bio-Trickling Filter 5) Photoionization The major odor-generating sections in a plant are influent pumping stations, grit traps and grit storage areas, primary clarifiers, sludge dewatering areas and any place where anaerobic reactions may happen.

View Complete Details

Valves and Flow Control

Butterfly valves 2) Gate valves 3) Knife gate valves 4) Non Return Valves 5) Check valves 6) Globe valves 7) Expansion joints 8) Electrical or Pneumatic Actuators for automatic operation. Valves are the controlling element in any fluid-handling system. They should be properly selected and cared for to give the best service at the lowest cost. The suitability of a valve for a particular application is decided by the materials used in relation to the conveyed fluid as well as its mechanical design.

View Complete Details

Water Hammer Protections Equipment

Surge Tanks 2) Surge Valves 3) Surge Towers 4) Air Inlet Valves or Release Valves Transmission pipelines are subject to the transient surges that are produced as results of rapid valve closing, failure or sudden starting or stopping of pump(s), power outage or power failure, and malfunctioning check valves.

View Complete Details

reverse

Reverse osmosis (RO) is a water purification technology that uses a semipermeable membrane. This membrane-technology is not properly a filtration method. In RO, an applied pressure is used to overcome osmotic pressure, a colligative property, that is driven by chemical potential, a thermodynamic parameter. RO can remove many types of molecules and ions from solutions and is used in both industrial processes and in producing potable water. The result is that the solute is retained on the pressurized side of the membrane and the pure solvent is allowed to pass to the other side. To be "selective, " this membrane should not allow large molecules or ions through the pores (holes), but should allow smaller components of the solution (such as the solvent) to pass freely.

View Complete Details

Tell Us What are you looking for? Will call you back

Contact Us

  • Anjum
  • , ajman, United Arab Emirates