Sheet Metal Electrical Enclosure #6331525

ECD:

ECD284, ECD384, ECD385 and ECD15 "Universal" drains and breathers have:

• Patented labyrinth design
• Capability to pass 50 cc of water per minute and 0.2 cubic feet or air per minute at atmospheric pressure
• ECD15 and ECD385 each have a well inside the inner, threaded end to provide for accumulation of sediment without clogging when used as a drain

"Standard" ECD drains and breathers have:

• Thread-in-thread design
• ECD 11, 13 have capability to pass 25 cc of water per minute and .05 cubic feet of air per minute at atmospheric pressure
• ECD387 and ECD16 are a unique thread-in-shaft design; the ECD387 and ECD16 can pass 15 cc of water per minute; the ECD16 can pass .01 cubic feet of air per minute

"Combination" ECD breather and drain:

• Provides ventilation to minimize condensation and drains accumulated condensate two functions performed by a single device installed in the bottom of an enclosure or conduit system
• Have the capability to pass 25 cc of water per minute and .10 cubic feet of air per minute at atmospheric pressure
• Thread-in-thread and labyrinth design

CD:

For use in conduit systems to:

• Drain accumulated condensate
• Provide ventilation to minimize condensation
• Drains are installed in hubs or drilled and tapped openings

ACD:

• Castellated locknuts that allow moisture to pass between the enclosure and the locknut to the drain holes in the fitting
• Available in brass, stainless steel (Type 316) or 30% glass filled nylon
• Captive "O" ring on recess of the face of the breather/drain to optimize ingress protection
• ATEX and CSA Certified for worldwide market acceptance
• Available with metric or NPT threads

• UL listed and CSA certified
• No need for threaded bushings, reducers, or special machining
• Corrosion- and heat-resistant polypropylene material
• Smooth flange providing easy wire pulling and protects conductors being installed
• Space-saving
• Molded ribs ensure a tight fit, preventing the liner from sliding out while conductors are being pulled
• Quick and easy to install

• Available in zinc, 316 stainless steel and non-metallic Krydon material in a variety of sizes