Our Products
Automotive Lights
2 Products availableSpying & Intelligence Devices
2 Products availableWe offer a complete product range of Ultraseal Reinforcing Tape, Denso Hi-Tack Tape, Paper Masking Tape, SAFETY WALK TAPE and TESA ANTI-SLIP TAPE
Denso Ultraseal Reinforcing Tape (Ultraseal RT) is designed for use as an outer armouring for Densyl or Denso Petrolatum Tapes. Ultraseal RT Tape is spirally applied and the coated with Denso Acrylic Topcoat or a solvent free Epoxy (Denso ST100) which quickly sets to form a tough UV resistant outer armouring. Denso RT Tape can also be used in the following applications:
Composition:The membrane consists of a non-woven synthetic fibre fabric laminated to a pressure sensitive, modified bitumen compound. The rolls are interleaved with a disposable release film
Denso Hi-Tack Tape is composed of a non-woven synthetic fabric impregnated and coated with an adhesive compound based on petrolatum, polymers and inert siliceous fillers.
Uses:A specially developed tape to protect irregular surfaces or where additional adhesion is required. Adhesion qualities are higher compared to other Denso Petrolatum Tapes.
Features:
Meets NACE RP0375-2006 Applied to marginally prepared surfaces (SSPC SP 2-3) High conformability with strong adhesion UV resistant Encapsulation of lead paint Can reduce or eliminate plant shut-down for maintenance Long term cost effective corrosion protection Instant and uniform protection given irrespective of the profile Resistant to acids, alkalis, salts etc. Elimination of failure due to intercoat contamination Years of proven effectiveness.
Application:Prepare surfaces by removing all loose scale, rust or other foreign matter in accordance to SSPC SP2 Hand Tool Cleaning or SP3 Power Tool Cleaning. High pressure water wash of 3, 000 7, 000 psi (20.68 48.26 MPa) is also suitable. Apply a thin film of Denso Hi-Tack Primer to serve as a primer. Do not overlap on the underside of horizontal surfaces. Do not attempt to work with lengths greater than 6 feet (1.8 m). Where possible, overlap from bottom upward to create a shingle type overlap. Press and smooth with special attention to overlap areas. Make sure tape is firmly pressed in all angles and corners and then along fl at surfaces to prevent air pockets, bridging, or stretching. Goal is to ensure intimate contact between tape and surface. Rivets, nuts, bolts may be rounded with Densyl Mastic, Denso Profiling Mastic or the use of a second layer of Denso Hi-Tack Tape for these areas only.
3M MASKING TAPE 1X50 METER, 36 ROLLS PER CARTON @ DHS.280
3M Paper Masking Tape 2321 is a chamois coloured crepe paper coated with a cross linked rubber resin adhesive.
A mineral-coated, slip-resistant material adhered by a durable resin to a pressure-sensitive adhesive backed plastic film. For light to heavy shoe-traffic areas. Highly durable surface withstands the rigors of equipment traffic. Available in clear rolls.
TESA Anti Slip Professional range is for use wherever safe footing is required. Anti Slip black/yellow is the ideal prevention of slipping and therefore helps to avoid accidents in the workplace. The very good adhesion of the product makes it suitable for demanding surfaces such as factory floors etc. The strong and durable adhesive coating provides a high Anti Slip effect for up to 1- 2 years in normal use areas. The Anti Slip tapes are hand tearable and no shrinkage occurs after application.
Technical DataBacking material -PVC filmType of adhesive-AcrylicAdhesion to steel-10N/cm
ELECTRICAL WARNING TAPE DETACTABLE 6 X300 YDS CAUTION- ELECTRICAL CABLE BELOW / IN ARABIC USD 90.00/-PER ROLL (IMAGE ATTACHED)
UNDERGROUND WARNING TAPES6 X 300 YARDS100 MICRON. @ DHS. 75.00 ELECTRICAL CABLE BELLOW RED ELECTRICAL CABLE BELLOW YELLOW CAUTION IRRIGATION PIPE BELLOW WASTE WATER PIPELINE BELLOW CAUTION TELEPHONE CABLE BELLOW CAUTION FIBER OPTICAL CABLE BELOW
The Scotch 23 electrical tape is a highly conformable self-amalgamating EPR based tape which simplifies high voltage and water resistant insulation because of its easy build-up and high stretch. It is suitable for use with all solid dielectric cable insulations. The tape conforms to BS3924 and IEC 454.
MAGNETIC TAPE 0.75MM THICK X 7.5 MM X 10 METER
MAGNETIC TAPE 0.75 MM X THICK X 12.5 MM X 10 METER
MAGNETIC TAPE 0.75 MM X THICK X 20 MM X 10 METER
Denso Hotline Tape is composed of a synthetic fabric impregnated with a special blend of high temperature petrolatum, mineral fillers and thermal extenders. It is backed with a thin high density polyethylene film.
Uses:A specifically developed tape for use in high temperature applications. Ideal for pipe work above or below ground, underneath pipe insulation or for pipes laid in concrete.
Features:
Meets NACE RP0375-2006 Service temperature up to 230F (110C) for above ground (180F / 83C for below ground) Applied to marginally prepared surfaces (SSPC SP 2-3) UV resistant Resistant to water, acid, salts & soil organics Encapsulation of lead paint Contains no solvents Easy applications from arctic to tropical temperatures Ready for immediate service after application.
Application: Prepare surfaces by removing all loose scale, rust or other foreign matter in accordance to SSPC SP2 Hand Tool Cleaning or SP3 Power Tool Cleaning. High pressure water wash of 3, 000 7, 000 psi (20.68 48.26 MPa) is also suitable. Spirally wrap the tape with a minimum 1 (25 mm) overlap. For severely corrosive environments, a 55% overlap is recommended. While wrapping, press air pockets out and smooth all lap seams. Where tape rolls need to be joined, ensure that the overlap is sufficient between rolls to provide continuous protection. For below ground applications, an approved Denso outerwrap is recommended. Note: for pipes with operating temperatures below 90F (32C), a thin layer of Denso Paste HT may be applied to aid in adhesion. Irregular surfaces such as valves, flanges, etc. may require the use of Densyl Mastic or Denso Profiling Mastic. Refer to the product sheets for these specific products for information on application and selection.
A robust heavy-duty tape, designed for protection of medium and large diameter pipes, welded joints, bends and fittings. The extremely tough pvc backing combined with polymer bitumen adhesive ensures complete protection and exceptional resistance to damage by impact, poor backfill or aggressive ground conditions. For the anti-corrosion protection of buried or immersed pipes and fittings. Suitable for machine or hand application.
Composition:A thick polymer bitumen adhesive laminated to a tough plasticised pvc backing. The adhesive layer is protected by an interleaving, wider than the tape, which is removed during application.