Larsa Lighting Dubai

Under Water Lighting With  outdoor lights you can create beautiful lighting in your garden. Our product range can illuminate paths and plants and emphasize details better than any traditional lights . There are many options available for underwater lighting.

Crystal Lights   Led crystals are easy to install with the enclosed locking spring Installing hole ø 14 mm Installation surface minimum 6 mm Led 1 W / 350 mA, IP44 Serial connection only

With optic fibres light can be taken everywhere. There is no electricity or heat in the fibres, there is only light. When producing a fibre bundle the projector end is hermetically sealed to keep the fibre clean and later prevent it from melting. The projector end is protected with a thermal protection filter. All fibre joints and endings in the fibre bundle are made without adhesives using the so-called dry polishing method which gives the best light conductivity performance on the market.

Functional lighting guarantees the adequate quantity of light required for comfort and to ensure the safe use of exterior areas, such as car parks, entranceways, passageways and paths. Diffused lighting is usually preferred to guarantee evenness in lighting all areas and surfaces. Access routes must be properly lit and direct or indirect glare should be avoided by performing thorough light engineering tests. It is therefore essential to assess the triangulation between an observer, the light source and reflective surface. The light engineering design will then identify the perfect solution to make full use of the areas and routes within the reference settings, without altering the general look and lighting quality of all the areas. The use of direct lighting and LED light sources moreover ensures significant energy saving and reduced maintenance.

A recessed light is a light fixture that is installed into a hollow opening in a wall/floor/ceiling. When installed it appears to have light shining from a hole in the wall/floor/ceiling, concentrating the light in a downward direction as a broad floodlight or narrow spotlight. There are two parts to recessed lights, the trim and housing. The trim is the visible portion of the light. It is the insert that is seen when looking up into the fixture, and also includes the thin lining around the edge of the light. The housing is the fixture itself that is installed inside the ceiling and contains the lamp holder. Application: Can be installed in any project where quality of products and low energy are required Lights for installation in shops, offices, hotels, etc.

Starlight Sets Starlight sets include a projector and fibres Some projectors have a twinkle wheel, when rotating the wheel creates a twinkle effect Starlight sets are also available with beautiful crystals which make the effect even more dashing Installation of a starlight set is possible also in ready premises with help of installation panels. The panels are made of light, fire resistant PIR foam. The panel is installed on the ceiling with small hooks and wires