Whitecroft Lighting

Dubai, United Arab Emirates

• An intelligent, programmable Lighting Control Module connection hub with 12 luminaire output sockets, 5 detector sockets and 5 override input sockets.
• Available in one of two formats:
  • Programmable Hub
  • Programmable Hub withDALI Dimming Card
• Detectors (supplied separately, requires patch lead for connnection to hub):
  • PIR detector (COMRCGAMMA)
  • Ceiling mounted microwave detector (COMRGGAMMA)
  • Corner mounted microwave detector (COMREGAMMA)
  • Luminaire integrated PIR detector (COMPL4GAMMA)
• Universal handheld controller supplied separately (COMHC)

• An intelligent, simple to install, cost effective lighting control connection hub available in switching/dimming and programmable versions
• Suitable for small areas such as classrooms or offices
• Available in one of two formats:
  • Connection Hub with switching and/or dimming
  • Programmable Connection Hub with dimming and DALI addressable
• Output connections:
  • 10 x 6A connections TANBOXA
  • 12 x 6A connections TANBOXAY
  • (12A maximum load)
• Single or dual channel switching or dimming
• Single fix moulded construction
• Handheld controller supplied separately

• The DALI addressable hub can be used in isolation to provide simple control to a localised application such as a classroom or office area. It has the added flexibility of being able to control multiple rooms up to the maximum addresses as detailed below.
• Low profile housing, perimeter mounted connector for mounting in limited void space
• Integrated mounting detail for surface, rod or trunking fixing
• Output connections
• 4 x 6 pole lighting outputs rated at 6A (16A total maximum load)
• Injection moulded flame retardant housing with mains entrycover and cable retainer
• Integrated DALI power supply

System Guidelines

• Up to 63 addresses per hub (each ballast, detector or switchconstitutes 1 address)
• Maximum 300m cable run and 250mA power consumption(typical 2mA per ballast)
• Up to 6A load on each of 4 socket outlets (16A totalmaximum load)

Simple Wiring

• Enhanced connectivity with CFL wiring components
• Switches and detectors can also be connected with CFL cables

Software Configuration

• Post installation software interface can be used to definedimming zones for daylight harvesting or switching zones

Scene Setting

• Touch button panels can be programmed to control a variety ofdifferent scenes by individually addressing each luminaire within the space
• Simple corridor linkage can be programmed so the luminairesstay on at a defined level whilst adjoining areas are occupied
• Multiple lighting levels can be selected from the switch panel
• Switching in X direction and daylight control in Y direction ispossible