Solvent Based Adhesives

DOLPHIN Contact Adhesive is a multi-purpose single component air drying SBS rubber based adhesive, suitably formulated for bonding various types of substrates. It has excellent green strength and bonds. This is a high solid, high viscosity contact adhesive and hence it is suitable for bonding porous substrates like foam, carpets, canvas, wood laminates and MDF laminates. It has excellent adhesion to common substrates and can be used in automotive decoration and repairs, upholstery works, furniture, leather & foot wear industries, fixing of metals & plastics, general house hold & industrial maintenance and DIY use. After drying, glue line is resistant to heat, moisture and also exhibits good low temperature flexibility.

- Multipurpose adhesive that bonds instantly on contact
- Bond most types of materials, and will even fix non-porous surfaces together e.g. metal to metal, making it ideal for a wide range of DIY tasks and household repairs.
- Ideal for bonding: wood, MDF, laminate, metal, PVC, leather, rubber, glass, mirror, stone, and ceramics

Apply adhesive evenly with any suitable equipment to uniform coat on both surface. Allow solvent to evaporate completely and then assemble the surface by applying normal hand pressure to give strong bond. Do not leave any air bubble on both applied surface.

Should be stored tightly closed and away from direct sunlight in a cool, wellventilated area between 5C to 38C. Close container tightly when not in use. Store away from ignition sources. Stirring required before use and if the product become very cold. Dolphin PIR Adhesive has a shelf life of 12 months from date of manufacturing.

DOLPHIN FLOOR ADHESIVE is based on very special type of synthetic resin, with additives, tackyfier and fine grade mineral fillers. DOLPHIN FLOOR ADHESIVE is water based adhesive and compatible with most of substrates

- Multi-Purpose Floor & PVC Vinyl Adhesive.
- Recommended for bonding of PVC sheet, Vinyl coverings and tiles, EPDM sheet, Polystyrene board, PU foam and similar material with concrete, metals and wooden substrates.
- Suitable to most of porous and nonporous surfaces.
- Recommended for both horizontal and inclined Structure.
- Suitable also for use with under floor heating installations. However the heating should be switched off at least 48 hours before and after the installation of floor coverings.

Apply the adhesive uniformly on the substrate using a fine trowel, brush or roller. Allow the adhesive to set for approx. 15-20 minutes to become tacky then lay the floor covering. It is essential to ensure good contact between the floor covering and adhesive. Bonding over existing floor coverings should be avoided. Clean any excess adhesive with water immediately. Do not allow adhesive to dry.

Store away from sunlight and preferably below 30C. Storage should be frost protected. DOLPHIN FLOOR ADHESIVE has 12 months shelf life if stored in required conditions