Our Products
Our Complete range of products are Dolphin PIR Adhesive, ADHESIVE, Dolphin Cornice Special Adhesive, MDF Kit Adhesive and PIR Adhesive.
DOLPHIN PIR Adhesive based on SBS Polymer. Dolphin PIR bonding with varieties of foams and metal substrates in pre- insulated duct system.
Application- Can be used in wide varieties of foams and metal substrates.- Recommended for HVAC applications.- Under deck insulation- Duct insulation (nitryl rubber to metal)
Application instructionApply adhesive evenly with any suitable equipment to uniform coat on both surface. Allow solvent to evaporate completely and then assemble the surface by applying normal hand pressure to give strong bond. Do not leave any air bubble on both applied surface.
Storage and Shelf lifeShould be stored tightly closed and away from direct sunlight in a cool, wellventilated area between 5C to 38C. Close container tightly when not in use. Store away from ignition sources. Stirring required before use and if the product become very cold. Dolphin PIR Adhesive has a shelf life of 12 months from date of manufacturing.
DOLPHIN CORNICE SPECIAL ADHESIVE SEALANT is a high quality cornice adhesive sealant. It is ideal for polystyrene, gypsum and PU board application.
Application- For bonding of polystyrene, gypsum and PU board cornice to wall partitions and ceiling applications.- Sealing gaps between cornice joints and cornice and wall.- Joints in the building industry between wood, metal window frames concrete and brick work.
Application instructionSURFACE PREPARATION
The substrate areas that will be in contact with sealant must be clean, dry and free of all loose materials, dust, dirt, rust, oil and other contaminants. Non - porous substrates should be cleaned with a solvent and a clean, lint - free, cotton cloth. Wipe dry immediately with clean cloth before the solvent evaporates from the surface.
TOOLING AND FINISHING
DOLPHIN CORNICE SPECIAL ADHESIVE SEALANT should only be used where slight joint movement is anticipated. For extremely deep joints, use foam joint filler. Tool sealant after application and before tack-free skin formation. Tooling of sealant should be done in one continuous stroke. Use masking tape adjacent to joint to obtain a cleaner joint. Remove masking tape immediately after tooling.
CLEANUP AND REMOVAL
Excess caulk should be cleaned off tools and non-porous surfaces while it is in the uncured state using a wet cloth. Cured sealant can only be removed mechanically.
When stored in original unopened container at or below 77F (25C) in dry warehouse conditions, DOLPHIN CORNICE SPECIAL ADHESIVE SEALANT has a shelf life of 24 months from manufacturing date. Containers should always be kept sealed when not in use